ImagickDraw::pathCurveToSmoothAbsolute
[edit] Last updated: Fri, 07 Jun 2013
ImagickDraw::pathCurveToSmoothRelative
(PECL imagick 2.0.0)
ImagickDraw::pathCurveToSmoothRelative — Draws a cubic Bezier curve
Описание
$x2
, float $y2
, float $x
, float $y
)К настоящему времени эта функция еще не была документирована; для ознакомления доступен только список аргументов.
Draws a cubic Bezier curve from the current point to (x,y) using relative coordinates. The first control point is assumed to be the reflection of the second control point on the previous command relative to the current point. (If there is no previous command or if the previous command was not an DrawPathCurveToAbsolute, DrawPathCurveToRelative, DrawPathCurveToSmoothAbsolute or DrawPathCurveToSmoothRelative, assume the first control point is coincident with the current point.) (x2,y2) is the second control point (i.e., the control point at the end of the curve). At the end of the command, the new current point becomes the final (x,y) coordinate pair used in the polybezier.
Список параметров
-
x2 -
x coordinate of the second control point
-
y2 -
y coordinate of the second control point
-
x -
x coordinate of the ending point
-
y -
y coordinate of the ending point
Возвращаемые значения
Эта функция не возвращает значения после выполнения.
add a note
User Contributed Notes
ImagickDraw::pathCurveToSmoothRelative - [0 notes]