PHPCon Poland 2024


Diese » PECL-Erweiterung ist nicht Teil von PHP.

Information zur Installation dieser PECL-Erweiterung finden sie im Kapitel Installation von PECL-Erweiterungen. Zusätzliche Informationen wie neue Releases, Downloads, Quelldateien, Maintainerinformation und ein CHANGELOG finden Sie hier: »

There are two packages for this extension: one package is for PHP versions 5.2.X, and the other package is for PHP 5.3.X. Select the package that is appropriate for the PHP version being used.

To install and enable the extension, follow these steps:

  1. Unpack the package into some temporary location.

  2. Copy the php_wincache.dll file into the PHP extensions folder. Typically this folder is called "ext" and it is located in the same folder with all PHP binary files. For example: C:\Program Files\PHP\ext.

  3. Using a text editor, open the php.ini file, which is usually located in the same folder where all PHP binary files are. For example: C:\Program Files\PHP\php.ini.

  4. Add the following line at the end of the php.ini file: extension = php_wincache.dll.

  5. Save and close the php.ini file.

  6. Recycle the IIS Application Pools for PHP to pick up the configuration changes. To check that the extension has been enabled, create a file called phpinfo.php with a PHP code that calls phpinfo function.

  7. Save the phpinfo.php file in the root folder of a IIS web site that uses PHP, then open a browser and make a request to http://localhost/phpinfo.php. Search within the returned web page for a section called wincache. If the extension is enabled, then the phpinfo output will list the configuration settings provided by the WinCache.

Hinweis: Do not forget to remove phpinfo.php file from the web site's root folder after verifying that extension has been enabled.

add a note

User Contributed Notes 3 notes

nils dot luxton at gmail dot com
12 years ago
If you're after pre-compiled binaries for WinCache, you can find them here: on the right-hand side of the page (under the Web Platform Installer button)
bobby mcbobbins
7 years ago
If you're looking for the DLLs for WinCache 2.0.0 (for use with PHP7+), here's a quick outline of the steps I took:

- Download the appropriate build from wincache's repository on sourceforge
- Run the .exe and extract the archive to a temporary directory
- Using 7zip, unpack the .msi within that temporary directory
- Add the .dll extension to the file named "php_wincache"
junk_1105 at hotmail dot com
7 years ago
The wincache version for 7.0 is compiled for php7.dll not the thread safe php7ts.dll. You may need to compile the source for wincache or change to the non thread safe version.
To Top