Internal option setting

The settings of PCRE_CASELESS, PCRE_MULTILINE, PCRE_DOTALL, PCRE_UNGREEDY, PCRE_EXTRA, PCRE_EXTENDED and PCRE_DUPNAMES can be changed from within the pattern by a sequence of Perl option letters enclosed between "(?" and ")". The option letters are:

Internal option letters
i for PCRE_CASELESS
m for PCRE_MULTILINE
s for PCRE_DOTALL
x for PCRE_EXTENDED
U for PCRE_UNGREEDY
X for PCRE_EXTRA (no longer supported as of PHP 7.3.0)
J for PCRE_INFO_JCHANGED

For example, (?im) sets case-insensitive (caseless), multiline matching. It is also possible to unset these options by preceding the letter with a hyphen, and a combined setting and unsetting such as (?im-sx), which sets PCRE_CASELESS and PCRE_MULTILINE while unsetting PCRE_DOTALL and PCRE_EXTENDED, is also permitted. If a letter appears both before and after the hyphen, the option is unset.

When an option change occurs at top level (that is, not inside subpattern parentheses), the change applies to the remainder of the pattern that follows. So /ab(?i)c/ matches only "abc" and "abC".

If an option change occurs inside a subpattern, the effect is different. This is a change of behaviour in Perl 5.005. An option change inside a subpattern affects only that part of the subpattern that follows it, so (a(?i)b)c matches "abc" and "aBc" and no other strings (assuming PCRE_CASELESS is not used). By this means, options can be made to have different settings in different parts of the pattern. Any changes made in one alternative do carry on into subsequent branches within the same subpattern. For example, (a(?i)b|c) matches "ab", "aB", "c", and "C", even though when matching "C" the first branch is abandoned before the option setting. This is because the effects of option settings happen at compile time. There would be some very weird behaviour otherwise.

The PCRE-specific options PCRE_UNGREEDY and PCRE_EXTRA can be changed in the same way as the Perl-compatible options by using the characters U and X respectively. The (?X) flag setting is special in that it must always occur earlier in the pattern than any of the additional features it turns on, even when it is at top level. It is best put at the start.

add a note

User Contributed Notes 2 notes

up
3
mike at clove dot com
14 years ago
When using the (?i:foo) syntax, it appears that the group is not included in the 'matches' argument unless it is nested in an additional set of parenthesis, for example: ((?i:foo))
up
2
mati_ at zenbe dot com
15 years ago
There is also the possibility to enable Modifier only on a specific group, so that the Modifier doesn't stay valid until end or deactivation with "(?-<modifier>)".

The Syntax for that is "?<modifier>:" on the beginning of the group, i.e. (?i:foo) matches on FoO.
To Top